Hydraulic Gate Closer-Black

Features: 
- Closes large and small gates up to 250 lbs. (depending on the model) easily and gently
- Hydraulic/Nitrogen Gas controlled closing speed
- Installs on side, top, middle or bottom of right or left hand gates
- Mounts on opening side of gate, pushing the gate closed
- Maximum opening angle of 100 degrees (LockeyUSA recommends use of a mechanical stop to restrict opening angle)
- Mounting brackets and fitting bar included
- The TB200/400/600 is not compatible with gates less than 30 inches wide
- Black powder coated steel
- Also available in Stainless Steel (TB200-SS/TB400-SS/TB600-SS)

IMPORTANT: MINIMUM/MAXIMUM OPERATING TEMPERATURE
- Minimum: 15 Degrees Fahrenheit
- Maximum: 100 Degrees Fahrenheit

Operation of the closer in temperatures below or above the minimum and maximum Operating Temperatures may result in improper operation or complete failure of the closer.


TB200 | 400 | 600 Opening Force Chart
Gate Closer     36" Gate      48" Gate       60" Gate          Constant Closing Pressure
ADDED OPENING FORCE
No Closer              3/4 lb.             1/2 lb.             1/4 lb.                                 0
TB200                    6 lbs.               4 lbs.                3 lbs.                                  45 lbs.
TB400                   10 lbs.              8 lbs.                6 lbs.                                  90 lbs.
TB600                   13 lbs.             10 lbs.               8 lbs.                                 135 lbs.                 

ADDED FORCE AT 45 DEGREE OPEN
TB200                     7 lbs.                5 lbs.              4.5 lbs.
TB400                   13 lbs.             9.5 lbs.                 8 lbs.
TB600                18.5 lbs.           13.5 lbs.              12 lbs.


NOTE: All measurements are taken using the 1st mounting hole on the post bracket with a 3" distance between the center of the hinge and the center of the post mounting bracket.  The opening pressure will INCREASE using the 2nd, 3rd and 4th holes.  These are "ADDED" opening pressures.  This chart DOES NOT take into consideration the hinge arrangements, quality of hinges, ease of operation, wind, etc.